Prompted by my friends over at the Liberal Gun Club, this is another in an occasional series of revisiting some of my old articles which had been published elsewhere over the years, perhaps lightly edited or updated with my current thoughts on the topic discussed. This is an article I wrote for Guns.com, and it originally ran 3/26/2011. Some additional observations at the end.
In an earlier article, when I said you’d get about a 15% increase in bullet velocity when using a pistol caliber carbine over a handgun, I lied.
Or, rather, I was neglecting one particular class of pistol ammunition which can develop upwards of a 50% increase in velocity/power in a carbine over a handgun: the “magnums,” usually shot out of a lever-action gun. This would include .327 Federal Magnum, .357 Magnum, .41 Magnum, and .44 Magnum.
These cartridges are rimmed, initially developed as powerful handgun rounds, and have their origins in black powder cartridges. This history is important for understanding why they are different than most of the other pistol cartridges and the carbines that use them.
We’ll start with the .357 Magnum, the first of these cartridges developed.
Back in the 1930s a number of people, Elmer Keith most notable among them, were looking to improve the ballistic performance of the .38 Special cartridge. This had been a cartridge originally loaded with black powder. Black powder takes up a lot of space – typically two to four times as much space as smokeless powder of a similar power. Meaning that when people started loading .38 Special cartridges with smokeless powder, the cartridge was mostly empty.
Now, if you were looking to get more power out of a .38 Special, and you saw all that unused space in the cartridge, what would be the obvious thing to do? Right – add more smokeless powder.
The problem is, many of the handguns chambered for the .38 Special using black powder were not strong enough to handle .38 Special cartridges over-charged with smokeless powder. And having handguns blowing up is rough on the customers. Heavier-framed guns could handle the extra power, but how to distinguish between the different power levels and what cartridge was appropriate for which guns?
The solution was to come up with a cartridge, which was almost the same as the .38 Special, but would not chamber in the older guns because it was just a little bit longer. This was the .357 Magnum.
There are two important aspects of the cartridge as far as it applies to lever guns. One is just simply the ability to use more gunpowder (a typical gunpowder load for a .357 magnum uses about half again as much as used in a .38 Special.) And the other is that you can get more complete combustion of the gunpowder used, perhaps even use a much slower burning gunpowder. This means that the acceleration of the bullet continues for a longer period of time.
How much of a difference does this make? Well, from the BBTI data for the .357 Magnum, the Cor Bon 125gr JHP out of a 4″ barrel gives 1,496 fps – and 2,113 fps out of an 18″ barrel. Compare that to the .38 Special Cor Bon 125gr JHP out of a 4″ barrel at 996 fps and 1,190 fps out of an 18″ barrel. That’s a gain of 617 fps for the .357 Magnum and just 194 fps for the .38 Special. Put another way, you get over a 41% improvement with the Magnum and just 19% with the Special using the longer barrel.
Similar improvements can be seen with other loads in the .357 Magnum. And with the other magnum cartridges. And when you start getting any of these bullets up in the range of 1,500 – 2,000 fps, you’re hitting rifle cartridge velocity and power. The low end of rifle cartridge velocity and power, but nonetheless still very impressive.
There’s another advantage to these pistol caliber lever guns: flexibility. Let’s take that .357 again. On the high end of the power band, you can use it as a reliable deer-hunting gun without concern. But if you put some down-loaded .38 Special rounds in it, you can also use it to hunt rabbit or squirrel. I suppose you could even use snake/rat shot loads, though most folks don’t recommend those loads due to concerns over barrel damage. Shooting mild .38 Special loads makes for a great day just plinking at the range.
One thing that I consider a real shame: you can get good quality lever guns for the .357, the .41, and the .44 magnums. But to the best of my knowledge, no one yet makes a .327 Magnum lever gun. I would think that such a gun would meet with a lot of popularity – properly designed, it should be able to handle the .327 Federal Magnum cartridge, the .32 H&R cartridge, even the .32 S&W Long. Again, with the right powder loads, this would give the gun a great deal of flexibility for target shooting and hunting small to medium sized game/varmits.
So, if you like the idea of having a carbine in the same cartridge as your handgun, but want to be able to maximize the power available to you, think about a good lever gun. It was a good idea in the 19th century, and one that still makes a lot of sense today.
Some additional thoughts …
I’m still a little surprised that no manufacturer has come out with a production .327 mag lever gun, though occasionally you hear rumors that this company or that company is going to do so. But I must admit that as time has gone on I’ve grown less interested in the .327 cartridge, since firearms options are so limited — definitely a chicken & egg problem.
One very notable absence from the above discussion is the .22 WMR (.22 Magnum), for the simple reason that we hadn’t tested it yet when I wrote the article. You can find a later article about it here.
Something I didn’t address when I wrote the article initially was ammunition which was formulated to take greater advantage of the longer barrel of a lever gun. Several manufacturers produce such ammo, perhaps most notably Hornady and Buffalo Bore. A blog post which includes the latter ammo out of my 94 Winchester AE can be found here, with subsequent posts here and here.
And lastly, there’s another cartridge we tested which really should be included in the “magnum” category, because it sees the same increasing power levels out to at least 18″ of barrel: .45 Super. This proved to be more than a little surprising, since it is based on the .45 ACP cartridge. Most semi-auto firearms which shoot the .45 ACP should be able to handle a limited amount of .45 Super, but if you want a lever gun set up to handle the cartridge you’ll have to get it from a gunsmith.
This content originally appeared at text and was written by admin This content is syndicated and does not necessarily reflect the views or positions of The Liberal Gun Club