First off - it’s confusing because Zastava also manufactures an M-70 rifle (AK).
It’s a dangerous thing to do, but I was browsing the gun deals sub Reddit. I’ve always made the mistake of missing really good surplus drops, so generally if it’s $2-300 I jump on it. I missed out on Nagant revolvers at $100 & and CZ 83 at $189. They get snatched up With in Hours, & then you can only
Find them for $200 more on auction site unless you get lucky with another surplus drop. These were bought up within a day for $225 shipped.
The pistol was made In the former Yugoslavia by the company Zastava which still exists today in Serbia. I watched a few reviews on you tube and pulled the trigger.I didn’t have any .32 ACP so I decided to get on reloading it (more on that later.)
The pistol arrived covered in crusty cosmolene - inside & out. I could barely get the slide off it was so encrusted. Once I was able to get it apart, I began scrubbing it in dawn and soapy water for quite some time. I disassembled the 2 supplied mags and did the same. I got most of the Cosmolene off then gave it a soak in CLP break free. Cleaned all that off.
I had to source components & dies from several different sources. They all arrived before the pistol did, which was less than a week. Loading the .32 ACP is a tedious process Becuase the charge is so small & the cases are difficult to manipulate.
(I tried to seat them at the depth The Lyman loading manual specified) but it was clearly not deep enough. Set depth in the manual was .988 and it was setting them almost all canted and wonky. I knew they were going to have problems just looking at them. And sure enough I did. I took it out for a test fire today and fired 2 rounds before I had a misfeed- but that was on me as the bullets were all set crookedly.
I went out and bought factory rounds (at $30 box, yikes) and they were visibly deeper - came home and they were set to .985. I will reset them, and run them through the die again set to .985. I have always had hard time loading FMJ semi auto rounds with out a visible cannelure. In fact, I use almost all cast bullets either pre. Cast or home cast to good effect. The only FMJs I load are 5.56 & those so in fact have a cannelure. Most pistol JHPs have one as well. This is why I prefer cast bullets as there is usually a crimp line so it removes the guess work.
The 2 rounds I did fire at about 7 yards we dead on with the minimal Sights.
The pistol came with a European style flap holster that was completely dried out - and not the type of holster I usually prefer - so I soaked it in neatsfoot oil. If I’m going to open carry a pistol with a flap holster In The out doors - it’s not going to be this one! Then, I set out making a new one - I aimed for one that would work either Strong side or cross draw. IfCertainly a holster I slammed together in a few hours & it’s far below my best effort.
Sent from my iPhone using Tapatalk
UPDATED: Ongoing Handgun Review: Surplus Zastava M-70 & m88a … or surplus Yugo arms adventures.
1
Last edited by INVICTVS138 on Wed Mar 09, 2022 6:22 pm, edited 1 time in total.